Euromix™ Concrete Finish


Euromix™ Concrete Finish is a flexible, water based, fine build, durable acrylic polymer topping and patching compound. It is designed to achieve a polished “concrete“ finish over suitable prepared building substrates.

Download Product Data Sheet

Download Material Safety Data Sheet

Product Summary


Euromix™ Concrete Finish provides a strong, flexible & smooth topping system to create an authentic concrete look. It can also be used over joints in fibre cement and other sheet materials.

Euromix™ Concrete Finish can be used for rectification and patch up work, facing-up and general preparation of many substrates where a smooth, fine concrete look topcoat finish is required.

Euromix™ Concrete Finish can be applied to both interior & exterior applications.

Product Name

 Euromix™ Concrete Finish.

Code

CONCFIN20, CONCFIN40,

CONCFIN60

Packaging

 15 litre plastic buckets. 

Appearance

In the bucket the material appears as a wet, grey, fine-grained plaster. When finished, in most circumstances it appears as an off-form concrete finish.

Application


Apply one build up layer of Euromix™ Concrete Finish with a stainless-steel trowel over the entire wall area. Apply in discontinuous strokes. This first layer can be 0.5 to 1.0mm thick to cover rendered surface.

After the first coat has been allowed to fully dry, give a good sanding to remove any imperfections, trowel marks etc.

Apply another two coats of Euromix™ Concrete Finish (depending on the smoothness or desired pattern) with a small steel trowel. Apply in very thin and tight layers and in discontinuous strokes making sure that material is not too wet or starting to dry.

Proceed to the polishing stage by repeatedly going over the finished surface, pressing firmly until the desired highlights appear.

A sealer coat should be applied if too exposed to weather

Euromix™ Concrete Finish Tutorial Video

0:00
0:00

Coverage


For topping allow 0.5kg / SQM (average coverage per 15L bucket is 30 SQM to 45 SQM).

Download Product Data Sheet

Download Material Safety Data Sheet

WHERE TO BUY

Drying and Curing


Avoid applying Euromix™ Concrete Finish in windy conditions or in temperatures outside the range 10°C to 30°C. Do not apply if rain or frost is imminent or possible before the product has properly dried. Where rain, or other exposure to moisture, is likely, it is required that the coating be shielded for at least 24 hours.

Drying and curing of the product is affected by type, dryness and porosity of the surface, temperature, humidity, ventilation, etc, and therefore drying and curing can only be given as a guide (at 25C & 50% RH):

Touch Dry

1 to 2 hours.

Recoat

2 hours.

Curing time

4 to 5 days, depending on weather.

Recommended Products


Euromix™ Sandstone Texture cannot be applied directly over PVC, polystyrene (EPS), AAC or other absorbent materials without the application of a suitable base coat first.

Euromix™ recommends the use of Euromix™ Acrylic Primer as the priming coat with Euromix™ Sandstone. 

Euromix™ Acrylic Primer

Euromix™ Primer is an acrylic surface primer, formulated to enhance the colour and adherence of Euromix™ textures and paints over most substrates, but particularly over render and masonry type surfaces.